Installing CMEM when Control-M is already installed
If Control‑M was installed without CMEM and subsequently CMEM is required, perform the following steps:
Note: This is relevant when Control‑O is not installed. If Control‑O is installed, see Installing Control-O.
- Specify IOA as the Product ID in the ICE IOA Installation Main menu.
Check and, if necessary, change the SSNAME CMEM-related parameter. For more information about this parameter, see Step 4 – Specify IOA parameters.
- Select Step 6.3 – Specify IOA computers (optional). Check or change the CTM2SBS CMEM-related parameter.
Check and, if necessary, change the computer parameters.
- Select Step 6.2 – Save parameters into IOA libraries to save the parameters in the installation libraries.
- If the IOA subsystem was not previously installed, perform Subsystem definition.
- Proceed with Step 7 – Install Event Manager (CMEM)/Control-O interface.
- For additional information, see Step 8 – JES considerations and Step 9 – Control-M amendments.
- Stop and restart the Control‑M monitor.
- Start CMEM using the command:
S CTMCMEM
This command should be issued in all computers where CMEM is to be active.