Control-M/Tape checks the values specified for CA-1 parameters in the TMOOPTxx member, and suggests values for Control-M/Tape installation parameters that are consistent with the CA-1 parameters at your site.
Figure 4 Conversion to Control-M/Tape Adjust CTTPARM Screen
---------------- Conversion to Control-M/Tape - Adjust CTTPARM ---------------
COMMAND ===>
Current Suggested
Value Value
---------- ----------
EXPDTYPE : CA1 CA1
DEFEXPDT : 0 CATALOG (IMPLEMENTATION BY A DEFAULT RULE)
DEFABEND : 0 LDATE/003 (IMPLEMENTATION BY A DEFAULT RULE)
OVERJCL : Y Y
EXPDTDDN : TMNOKEY TMNOKEY
CYCLECNT : JOB JOBDATE
RTNTYPE : (VOL,GROUP) (VOL,GROUP)
RTNUPD : CRE CRE
VLTBYDS1 : Y Y
GRACECAT : 0 101
GRACECYC : 0 102
EXPCAT : Y Y
Accept suggested values ===> (Yes/No)
The Current Value column indicates the current values of these parameters in member CTTPARM. The Suggested Value column indicates the values recommended by the conversion tool (based on the settings for CA-1 parameters at your site).
Note: IMPLEMENTATION BY A DEFAULT RULE indicates that the value specified for the CA-1 parameter is implemented in Control-M/Tape by an automatically defined rule that performs the same function as the parameter value.
This screen enables you to modify the Control-M/Tape installation parameters that are relevant to the conversion process. Certain other Control-M/Tape installation parameters may also need to be modified, for example, when converting before activation of Control-M/Tape in a new global operation mode. These parameters are described in the relevant chapters of the Control-M/Tape Implementation Guide, and in the Control-M/Tape chapter of the INCONTROL for z/OS Installation Guide.
Parent Topic |