|
|
|
|
|
The Control-M Job Scheduling Definition screen is used to define, display and modify production parameters of a specific job. This screen can be entered directly from the entry panel or from the Job List screen. Update of parameters is not permitted in Browse mode.
Note: The format of the Job Scheduling Definition screen for SMART Table Entities is slightly different than the format shown below and is described in Scheduling Definition for SMART Table Entities.
Figure 17 Job Scheduling Definition Screen
JOB: BACKPL02 LIB CTM.PROD.SCHEDULE TABLE: BACKUP
COMMAND ===> SCROLL===> CRSR
+-----------------------------------------------------------------------------+
MEMNAME BACKPL02 MEMLIB CTM.PROD.JOBLIB
OWNER M44 TASKTYPE JOB PREVENT-NCT2 Y DFLT N
APPL APPL-L TBL BKP-PROD-L RBC
DESC DAILY BACKUP OF SPECIAL FILES FROM APPL-L
OVERLIB CTM.OVER.JOBLIB STAT CAL
SCHENV SYSTEM ID NJE NODE
SET VAR
CTB STEP AT NAME TYPE
DOCMEM BACKPL02 DOCLIB CTM.PROD.DOC
===========================================================================
SCHEDULE RBC
RELATIONSHIP (AND/OR) O
DAYS ALL DCAL
AND/OR
WDAYS WCAL
MONTHS 1- Y 2- Y 3- Y 4- Y 5- Y 6- Y 7- Y 8- Y 9- Y 10- Y 11- Y 12- Y
DATES
CONFCAL SHIFT RETRO N MAXWAIT 00 D-CAT
MINIMUM PDS
DEFINITION ACTIVE FROM UNTIL
===========================================================================
IN START-DAILY-BACKUP ODAT
CONTROL
RESOURCE INIT 0001 CART 0001
PIPE CTM.PROD.PIPE
FROM TIME + DAYS UNTIL TIME + DAYS
DUE OUT TIME + DAYS PRIORITY SAC CONFIRM
TIME ZONE:
===========================================================================
OUT BAKCKPL02-ENDED-OK ODAT +
AUTO-ARCHIVE Y SYSDB Y MAXDAYS MAXRUNS
RETENTION: # OF DAYS TO KEEP # OF GENERATIONS TO KEEP
SYSOUT OP (C,D,F,N,R) FROM
MAXRERUN RERUNMEM INTERVAL FROM
STEP RANGE FR (PGM.PROC) . TO .
ON PGMST PROCST CODES A/O
DO
ON SYSOUT FROM 001 TO 132 A/O
DO
ON VAR
DO
SHOUT WHEN TIME + DAYS TO URGN
MS
===========================================================================
APPL TYPE APPL VER
APPL FORM CM VER
INLINE JCL: N
======= >>>>>>>>>>>>>>>>>>> END OF SCHEDULING PARAMETERS <<<<<<<<<<<<<<<< =====
COMMANDS: EDIT, DOC, PLAN, JOBSTAT 11.27.41
Note: The PIPE parameter is displayed only if MAINVIEW Batch Optimizer (MVBO) is installed. RETENTION parameters # OF DAYS TO KEEP and # OF GENERATIONS TO KEEP are displayed only at sites that use the History Jobs file.
The job scheduling definition occupies more than one screen.
To delete a parameter on the screen, simply erase it with the EOF key or blank it out. If additional action is required, Control-M issues appropriate instructions.
Parent Topic |