Customization required due to modifying a system JES2 SID

1. Perform Step 6.3 – Specify IOA computers (optional) to update the SYSID parameter in the IOACPRM member to match the new configuration.

   Do not change the order of the SYSIDs in the IOACPRM member. If you do change the order, perform all steps as described in Adding, deleting and/or changing an SMFID in the computer list.

2. If neither CMEM nor Control‑O is installed, skip to step 5 below. Otherwise, continue with the next step.

   If Control‑O is installed and active, it should be restarted using the following operator command:

   S CONTROLO

   The active Control‑O will be stopped, and a new monitor will be started. This command should be issued in all computers where Control‑O is active.

3. Stop and restart the Control‑M monitor.
4. If Control‑D is installed and active, stop and restart the Control‑D monitor.