Step 5. Install Control-M/Restart

If you do not intend to run Control‑M/Restart at your site, skip this step.

Install Control‑M/Restart following the instructions in the Control‑M/Restart installation chapter of the INCONTROL for z/OS Installation Guide: Installing. Observe the following rules:

1. Assign parameter values

   Use ICE to assign values to the current release parameters in the following table that are different than the values of the corresponding parameters in the version you are now using. For details, see the DEFPARM member in the IOA.PARM library.

   Table 6 Control‑M/Restart parameters

   Parameter	Description
   %ILPREFR%	Prefix of the Control‑M/Restart Installation library
   %OLPREFR%	Prefix of the Control‑M/Restart Operations libraries

2. Assign values in the CTRPARM member

   For the following parameters, assign values that are different than the values in the version you are now using. To find the values in your current system, see the CTRPARM member in the IOA.PARM library.

   • CTRPROC
   • AMPREFR

The mapping of certain parameters in earlier versions of Control-M/Restart has been changed to Control-M/Restart version CR parameters, as shown in the following table.

Table 7 CTRPARM parameters