Starting the AutoOPERATOR interface

The STARTAAO command instructs a Control-O subsystem to restart the AutoOPERATOR interface. This includes a possible initialization of the interface, if it was not yet initialized by another subsystem or by registration of the current subsystem in the AutoOPERATOR interface.

Either of the following message sequences indicates a successful installation of the AutoOPERATOR interface:

• for the first Control-O subsystem to initialize:

CTO83AI INITIALIZATION OF AUTOOPERATOR SUPPORT STARTED          

CTO83EI SUBSYSTEM REGISTERED WITH AUTOOPERATOR INTERFACE        

CTO83FI INITIALIZATION OF AUTOOPERATOR SUPPORT ENDED SUCCESSFULLY

• for any subsequent Control-O subsystem that initializes:

CTO83EI SUBSYSTEM REGISTERED WITH AUTOOPERATOR INTERFACE        

CTO83FI INITIALIZATION OF AUTOOPERATOR SUPPORT ENDED SUCCESSFULLY