Stopping the AutoOPERATOR interface

The STOPAAO command instructs a Control-O subsystem to deactivate the AutoOPERATOR interface. This includes removing the registration of the current subsystem from the AutoOPERATOR interface, and possibly removing the AutoOPERATOR interface from common storage, if no other subsystems are using it.

Either one of the following message sequences indicates a successful deactivation of the MAINVIEW interface:

• For all but the last Control-O subsystem to shut down:

CTO83KI DEACTIVATION OF AUTOOPERATOR SUPPORT STARTED             

CTO83OI SUBSYSTEM REGISTRATION REMOVED FROM AUTOOPERATOR INTERFACE

CTO83QI DEACTIVATION OF AUTOOPERATOR SUPPORT ENDED SUCCESSFULLY  

• for the last Control-O subsystem that shuts down:

CTO83OI SUBSYSTEM REGISTRATION REMOVED FROM AUTOOPERATOR INTERFACE

CTO83QI DEACTIVATION OF AUTOOPERATOR SUPPORT ENDED SUCCESSFULLY