ctm_pause

The ctm_pause utility stops Control-M/Server from submitting jobs.

Stopping Control-M/Server from Submitting Jobs Using the ctm_pause Utility

This procedure describes how to pause a Control-M/Server, which enables you to keep jobs from executing until you resume the Control-M/Server.

Begin

  • From a command line, run one of the following commands:

    • Pause: ctm_pause Y

    • Resume: ctm_pause N

You might want to pause submitting new jobs when you want to investigate abnormal behavior in Control-M/Server, without shutting it down, or if you want to start it up after its upgraded.