Editing JCL from the Active Environment

Clearly there is no point in restarting a job that will continue to fail because the problem has not been corrected. But now that you know the cause of the failure, you can correct it and then restart the job.

You can correct the JCL of this job by using the JCL option in the Active Environment screen.

1. Exit the Control-M Log screen. The Active Environment screen is displayed.

   Note the option J (JCL) at the bottom of the screen. If the list of commands is displayed instead of the list of options, enter the OPT command to toggle to the list of options.

2. Enter option J for the job. The JCL is displayed in ISPF edit mode.
3. Change the condition code of C0008 in step S3 to C0000, and exit the JCL. The Active Environment screen is displayed. You can now restart the job.