|
|
|
|
|
An example of the Zoom screen for Table Entities is shown below.
As noted earlier, a job must be placed in the Held state before entering the Zoom screen if changes are to be saved. When a SMART Table Entity is held, changes to jobs within the SMART Table can be saved without having to separately place a hold on each job.
All information applicable to the regular Zoom screen applies to the SMART Table Entity Zoom screen as well. All fields in the SMART Table Entity Zoom screen also appear in the Zoom screen for regular job scheduling definitions. For a description of the fields in the SMART Table Entity Zoom screen, refer to the descriptions of the regular Zoom screen, the Job Scheduling Definition screen, and the SMART Table Entity screen.
Figure 52 Zoom Screen for SMART Table Entities
----------------------------- CONTROL-M ZOOM SCREEN ----------------------(3.Z)
COMMAND ===> SCROLL===> CRSR
+-----------------------------------------------------------------------------+
OWNER N04A TASKTYPE TBL
SCHDTAB SPDCRP SCHDLIB CTM.PROD.SCHED
APPL GRP ACCCOUNTING RBC
JOBNAME JOBID ODATE 060601 ORDERID 000IH TBL MAXWAIT 00
DESC
KEEP JOBS UNTIL REMOVED N KEEP AT LEAST 00 DAYS AFTER ENDED NOT OK
SET VAR
DOCMEM ACCOUNT DOCLIB CTM.CMEM.DOC
===========================================================================
IN
CONTROL
FROM TIME + DAYS UNTIL TIME + DAYS PRTY 11 CONFIRM N
DUE IN + DAYS ELAPSE DUE OUT + DAYS
TIME ZONE: WAIT FOR ODATE: N
===========================================================================
OUT
MAXRERUN
CYCLIC TYPE: C INTRVL FROM NXT RUN
INTERVAL SEQUENCE: + + + + +
SPECIFIC TIMES: TOLERANCE 000
ON TABLE-END OK
DO COND ACCOUNTING-OK 0909 +
ON VAR
DO
SHOUT WHEN TIME + DAYS TO URGN
MS
====== >>>>>>>>>>>>>>>>>>> END OF JOB PARAMETERS <<<<<<<<<<<<<<<<<<<<<<< =====
COMMANDS: SAVE DOC NOTE JVER 11.41.46
Parent Topic |