To install Control‑M/Tape parallel execution support, do the following:
If the new Control‑M/Tape version is active, bring it down using the following operator command:
S xxxINIT,PARM=TERM
where xxx is the procedure prefix selected during the new Control‑M/Tape version installation.
Parameter |
Minor step in major step 1 of Customization |
---|---|
MODET=TEST |
Minor step 1 - Initialization Parameters |
PARALLEL=S |
Minor step 1 - Initialization Parameters |
RBTTYPE=NONE |
Minor step 10 - Automated Tape Libraries |
Ensure that the SVC number for the new version (the SVCNUM parameter in the CTTPARM member) is different from the SVC number used by the earlier version. Identical SVC numbers produce unpredictable results.
Ensure that the following parameter value is already set in the CTTPARM member of the version you are upgrading from:
PARALLEL=N
S xxxINIT
In this command, xxx is the procedure prefix selected during new Control‑M/Tape version installation.
Parent Topic |