Messages RUN200 through RUN2xx

This group includes messages for the Control-M for z/OS, Control-M/Assist, Control-M/Links for z/OS, and Control-M/Restart products.

RUN280W OPTIMIZE SUPPORT NOT ACTIVATED

Explanation: A Load-Index-related modify command has been issued but the Control-M Workload Optimization feature is not enabled.

Corrective Action: Enable the Workload Optimization feature by setting the OPTMODE parameter to Y, as discussed in Optimization section in the INCONTROL for z/OS Installation Guide: Customizing.

RUN284I DEST TABLE LOAD SUCCESSFUL: NEWDEST=tableName

Explanation: This information message indicates that as a result of an operator NEWDEST command, the Control-M monitor successfully loaded the destination table identified in the message.

Corrective Action: No action is required.

RUN285E NEWDEST PARAMETER MISSING OR INVALID

Explanation: The destination table passed to the Control-M monitor by means of an operator NEWDEST command is invalid or missing.

The specified destination table is not loaded.

Corrective Action: Enter the NEWDEST command specifying a destination table which has been previously defined in a library concatenated to the STEPLIB DD statement of the Control-M procedure.