Considerations

When Control‑O and IOAGATE are installed, the following modify commands are available:

These commands are available only if parameter CTOGATE is set to YES in member CTOPARM.

For a list of systems to which Control‑O is connected to the IOAGATE and using Sysplex, issue the following command:

In the case of Sysplex, the first Sysplex name is also listed.

The following is displayed as a result of this command:

CTO356I DISPCOMM             

Control‑O COMMUNICATION MAP  

VTAM CONNECTIONS:            

NAME     LU        APPL       

CTO01    CTOLU01  O          

CTO03    CTOLU03  O          

SYSPLEX CONNECTIONS:         

ESA1

• To enable communication after the STOPCOMM modify command was issued, use the command

  F CONTROLO,STARTCOMM

  Note: This command is available only if parameter CTOGATE is set to YES in member CTOPARM and if communication was stopped.

• To disable communication in Control‑O, use the command

  F CONTROLO,STOPCOMM

  Note: This command is available only if parameter CTOGATE is set to YES in member CTOPARM and if communication was started.

• During problem determination, to snap the system network map, use the command

  F CONTROLO,SNAP=SYS