Loading the New Copy of CTOAODT

The procedure for loading the new CTOAODT copy in all IOA environments on the system is shown in the following steps:

1. Load the new module with the following operator command for the Control‑O Monitor of the environment in which the PTF was applied:

   F CONTROLO,STARTOE

2. Verify that the following message appears:

   CTO781I OPENEDITION INTERFACE MODULE SUCCESSFULLY LOADED

3. Restore the OpenEdition support in the rest of the IOA environments where it was previously stopped, by running the following operator command for the Control‑O Monitor of each one of them:

   F monitor,STARTOE

4. Alternatively, restart the appropriate monitor if it was stopped.