On statements are events under which the rule is to be performed. On statements are performed sequentially. For more information about On Statements in Control-M Event Manager, see Types of Events Managed by CMEM in INCONTROL User Guide.
NOTE: You can add On Statements by clicking on in the On Statements tab. You can delete an On Statement by clicking next to the On Statement field.
You can select the following On Statements:
Job Arrive: Defines the arrival of a job on the JES spool from any source, such as jobs submitted by a TSO user or by CICS or jobs received over an NJE network. This occurs when a job is not submitted by Control-M monitor. For more information about Job Arrive parameters, see Job Arrive parameters.
Job End: Defines the completion of a job regardless of its source. For more information about Job End parameters, see Job End parameters.
Step End: Defines the termination of a job step. The step is the lowest part of the a job. For more information about Step End parameters, see Step End parameters.
DSN Event: Defines the file status and state when the file is released from the job. For more information about DSN Event parameters, see DSN Event parameters.
Auto Operator Request: Defines a perform request from MainView AutoOperator, when MainView AutoOperator is installed.
On Statements are connected by selecting one of the following in each of the on statement fields:
And: Indicates AND logic between the two ON statements
O: Indicates OR logic between the preceding and following sets of ON statements
N: Indicates AND NOT logic between the two ON statements
NOTE: If you select one On Statement the selection does not appear.