Running the ctmspdiag utility

This procedure describes how to run the ctmspdiag utility, which enables you to print or erase diagnostic messages recorded from stored procedures (SPs) in the Control-M/Server database.

To run the ctmspdiag utility:

1. Do one of the following:
   • UNIX: Log on to a Control-M/Server account
   • Windows: Open a command prompt window where Control-M/Server is installed.
2. Type one of the following commands to invoke the ctmspdiag utility:
   • ctmspdiag -SET -SPNAME <storeProcedureName> -MODE <Y/N>
   • ctmspdiag -PRINT -SPNAME <storeProcedureName>
   • [-FROM_DATE<timeStamp>] [-TO_DATE <timeStamp>]
   • ctmspdiag -DEL -TO_DATE <timeStamp>[-SPNAME <storeProcedureName>]
   • ctmspdiag -SHOW [-SPNAME <storeProcedureName>]
   • ctmspdiag -TRUNCATE

For the Control-M parameter name, see Parameter name cross references. For more details on the ctmspdiag parameters, see ctmspdiag parameters.