Running the ctmdbcheck utility

This procedure describes how to run the ctmdbcheck utility, which displays information about the memory capacity and the status of the Control‑M/Server database.

To run the utility:

1. Do one of the following:
   • UNIX: Log on to a Control-M/Server account
   • Windows: Open a command prompt window where Control-M/Server is installed.
2. Enter one of the following the commands:
   • ctmdbcheck

     Monitor the database and the transaction log using the ctmdbcheck utility with the following syntax according to the database in use.

   • For Oracle specify the following command:

     ctmdbcheck <generalThreshold%>

   Only data usage may be checked for existing Oracle databases.

   • For PostgreSQL, enter the following command:

     ctmdbcheck <generalThreshold%>

   • For MSSQL enter the following command:

     ctmdbcheck [-d <dbThreshold%>] [-l <logThreshold%>][-n]

     ctmdbcheck 20

     db total = 47757170 KB

     data used = 6633 KB (0.01%)

     Checking database...

     Database is OK

     These commands trigger a Shout message to Control-M/Server if more than the specified percentage of the database or the database transaction log are full. This message can then be used to trigger actions that will extend the appropriate Control‑M/Server database component.

For the Control-M parameter name, see Parameter name cross references. For more details on the ctmdbcheck utility, see ctmdbcheck utility parameters, ctmdbcheck utility output parameters, and ctmdbcheck utility examples.