Setting Cyclic jobs

This procedure describes how to set the rerun settings. It enables you to set how a job is rerun.

To set cyclic jobs:

1. In the Workspace, select the job.
2. Click .
3. In the Scheduling tab, Rerun Settings area, select .

   The Cyclic Job Run Times dialog box appears.

4. To set Run Every rerun interval, do the following:
   1. Select Rerun Every.
   2. Set the interval, and one of the following units:
      • Minutes
      • Hours
      • Days
5. To set the Rerun using the following interval sequence rerun interval, do the following:
   1. Click Rerun using the following interval sequence.
   2. Click .
   3. Set Unit and the Interval Length.
   4. Repeat step b as necessary.
   5. In the All Intervals are from Job's field, select Start, End, or Target.
6. To set Specific Times, do the following:
   1. Click Run at.
   2. Click .
   3. Set the Time.
   4. Repeat step c as necessary.
   5. Set the Tolerance (Minutes) field.
7. Click OK.

   The Rerun settings appear in the box below the Cyclic field.