Creating an Out Condition

This procedure describes how to create an Out Condition for a Job which enables you to establish that the condition is added (or removed) when the Job ends.

Before you begin

Successful completion of the following:

• Open the Workspace that holds the Jobs with the intended Out Condition. For more information, see Setting up a Control-M Workspace.
• You must have a Job flow with at least two Jobs to create an Out Condition.

To create an Out Condition:

1. In the Workspace, select the Job.

   The Job properties pane appears on the right.

2. Click .

   The Job properties are enabled for definition.

3. Select the Actions tab.
4. In the Out Conditions section, click .
5. In the Name field, type a name for the Out Condition. For more information, see Out Condition parameters.
6. From the Order Date drop-down list, select the order date for the Job to run. For more information, see Out Condition parameters.
7. From the Add/Remove The Condition drop-down list, select Add or Remove. For more information, see Out Condition parameters.

   The Out Condition is created.

8. To set Output Handling, set the Action field.

   An Out Condition is displayed in the Job flow as a solid line.