This procedure describes how to create an In Condition for a Job which enables you to establish the requirement that the condition must exist before the Job can run.
Before you begin
Successful completion of the following:
Open the Workspace that holds the Jobs with the intended In Condition. For more information, see Setting up a Control-M Workspace.
You must have a Workspace with at least two Jobs to create an In Condition.
To create an In Condition:
In the Workspace, select the Job.
The Job properties pane appears on the right.
Click .
The Job properties are enabled for definition.
Select the Prerequisites tab.
In the In Conditions section, click .
In the Name field, type a name for the In Condition. For more information, see In Condition parameters.
From the Order Date drop-down list, select the order date for the Job to run. For more information, see In Condition parameters.
Click , select the relationship between conditions. For more information, see In Condition parameters.
If you select Set Manually, define the following:
If you want to add brackets, from the Opening Bracket and Closing Bracket drop-down lists, select the brackets. For more information, see In Condition parameters.
From the Relationship drop-down list, select the relationship between the In Conditions. For more information, see In Condition parameters.
Note: If you define your In Conditions relationship manually, and then select the AND/OR between all, your manual definitions are deleted.
.
.
, select the relationship between conditions. For more information, see In Condition parameters.