Auto Routing

Control-M JCL Verify can analyze the JCL and adjust the routing criteria so the JCL will be verified on a different Control-M JCL Verify monitor or system, according to JES commands or JOB card routing keywords. Note that only verification can be performed with Auto Routing.

Auto Routing is disabled in the following cases:

• The member contains multiple jobs.
• The request is for verifying an entire library.
• Multiple members are specified in CTJVER SYSIN.

In all these cases, Auto Routing is deactivated and the verification is performed locally.

Auto Routing is supported for

• CTJVER utility for regular JCL and Control-M schedule definitions. See parameter AR in CTJVER Procedure parameters (in the INCONTROL for z/OS Utilities Guide).
• CTJXVER edit macro, see parameter AUTO ROUTE in Verification mode.

Parameter to enable Auto Routing:

AR= Whether to enable Auto Routing.

Valid values are:

• Y - Yes
• N - No
• D - as Defined by the AROUTE parameter in the CTJPARM