The following types of line editing commands exist in the Edit environment.
Table 286 Delete Commands
Command |
Effect |
---|---|
DS |
Delete a single line. |
DL |
Delete a logical line. |
DB |
Delete a logical block. |
DD |
Delete lines between two DD specifications. |
D |
Delete a line. Control-V determines whether to delete a single or logical line based on the line type. |
Table 287 Copy Commands
Command |
Effect |
---|---|
CS |
Copy a single line. |
CL |
Copy a logical line. |
CB |
Copy a logical block. |
CC |
Copy lines between two CC specifications. |
C |
Copy a line. Control-V determines whether to copy a single or logical line based on the line type. |
Copy commands are used in conjunction with Location commands. The lines or blocks are placed at the position indicated by Location command A or B (described below). |
Table 288 Move Commands
Command |
Effect |
---|---|
MS |
Move a single line. |
ML |
Move a logical line. |
MB |
Move a logical block. |
MM |
Move lines between two MM specifications. |
M |
Move a line. Control-V determines whether to move a single or logical line based on the line type. |
Move commands are used in conjunction with Location commands. The lines or blocks are placed at the position indicated by Location command A or B (described below). |
Table 289 Repeat Commands
Command |
Description |
---|---|
RS |
Repeat a single line. |
RL |
Repeat a logical line. |
RB |
Repeat a logical block. |
RR |
Repeat lines between two RR specifications. |
R |
Repeat a line. Control-V determines whether to repeat a single or logical line based on the line type. |
The repeated lines or blocks are placed immediately after the lines or blocks that has been repeated. |
Table 290 Insert Commands
Command |
Description |
---|---|
I (Insert) |
Insert a new logical line or block after the logical line or block marked with an I. |
Table 291 Location Commands
Command |
Description |
---|---|
Indication of the position where lines or blocks should be placed. |
|
A (After) |
Indicates that lines or blocks should be placed after the line marked with an A. |
B (Before) |
Indicates that lines or blocks should be placed before the line marked with a B. |
Location commands A and B are used in conjunction with Copy (C, CS, CL, CC, CB), and Move (M, MS, ML, MM, MB) commands. |
Parent Topic |