General Information

Statement DO NAME specifies either the report name or the line and column range on the report page where the report name can be found. Later, the report name can be used as a key for retrieving the report by the recipients or for sorting multiple reports within a printing mission.

An asterisk should be entered if the report name is to be found on the report page; the appropriate line and column references are then specified. IF DO NAME is set to * and a report page has blanks in the from-until COL range, the report name for that report page is set to NONAME.

Parameter LINE is optional. If it is omitted, the line in which the WHEN string was found is used.

The report name specified is used for all pages until a new DO NAME is activated. The same user cannot receive the same report page more than once, even under different report names.

The report name field can be set to special values (described below) which begin with %%.

To define the report name extracted from report content, do the following:

1. In the report_name field, type * (asterisk), and press Enter. The LINE and COL fields are displayed. The length of the report_name field is reduced to twenty characters.
2. Enter the line and column numbers for the report field you want to extract.

Note: To switch back to the literal in the report_name field, replace the * in the report_name field with any character other than a blank or * (asterisk), and press Enter. The LINE and COL fields are hidden, and the length of the report_name field is restored to its default.