Activating Control-M/Tape Support for DFSMS

To activate the DFSMS interface of Control-M/Tape, perform the following steps:

1. Edit the CTTPARM member in the IOA PARM library:
   1. Specify Y for the SMSINTR parameter.
   2. Review the description of the OVERJCL installation parameter, and determine if its value should be changed.
   3. Save this member.
2. If Control-M/Tape is active, refresh the installation parameters in memory. To do this, issue the following operator command:

   S CTTINIT,PARM='MODE=RELOAD,TBLT=PARM'

   If Control-M/Tape is not active, changes to the Control-M/Tape installation parameters are automatically loaded the next time Control-M/Tape is started.

   Optionally, you can define rules that use Management Class as a selection criteria (meaning, ON MGMTCLAS). If you define such rules, you must refresh the Control-M/Tape rules in memory. To do this, issue the following operator command:

   S CTTINIT,PARM='MODE=RELOAD,TBLT=RULE'