|
|
|
|
|
You can control generic processing by turning it off and on. You use operator commands to perform this process. By default, generic processing will be started when Control-D is started (unless it was previously deactivated by an operator command).
One reason that generic processing may be deactivated is if the Control-D New Day Procedure (CTDNDAY) fails to schedule the Generic Missions to the Active Missions file. When generic processing is deactivated, the Generic Missions will not select outputs from the defined generic classes.
The operator command to stop generic processing is:
F CONTROLD,STOPGEN
The operator command to start generic processing is:
F CONTROLD,STARTGEN
Only in extreme situations should generic processing be stopped and started manually.
Parent Topic |