DS

Delete a single line.

DL

Delete a logical line.

DB

Delete a logical block or sub-block.

DD

Delete lines between two DD specifications.

D

Delete a line. Control-M/Tape determines whether to delete a single or logical line based on the line type.

CS

Copy a single line.

CL

Copy a logical line.

CB

Copy a logical block or sub-block.

CC

Copy lines between two CC specifications.

C

Copy a line. Control-M/Tape product determines whether to copy a single or logical line based on the line type.

Copy commands are used in conjunction with Location commands. The lines and blocks are placed at the position indicated by Location command A or B (described below).

MS

Move a single line.

ML

Move a logical line.

MB

Move a logical block or sub-block.

MM

Move lines between two MM specifications.

M

Moves a line. Control-M/Tape determines whether to move a single or logical line based on line type.

Move commands are used in conjunction with Location commands. The lines and blocks are placed at the position indicated by Location command A or B (described below).

RS

Repeat a single line.

RL

Repeat a logical line.

RB

Repeat a logical block or sub-block.

RR

Repeat lines between two RR specifications.

R

Repeat a line. Control-M/Tape determines whether to repeat a single or logical line based on line type.

The repeated lines and blocks are placed immediately after the lines and blocks marked with the command.

I

Inserts a new logical line or block after the logical line or block marked with an I.

Indication of the position where lines or blocks are placed.

A (After)

Indicates that lines or blocks are placed after the line marked with an A.

B (Before)

Indicates that lines or blocks are placed before the line marked with a B.

Location commands A and B are used in conjunction with Copy (C, CS, CL, CC, CB), and Move (M, MS, ML, MM, MB) commands.