AutoSave and Saving Documentation

Documentation changes can be saved upon exiting the Vault Definition screen. When there are documentation changes, a Save Documentation window can be displayed depending on the value of the AUTO-SAVE DOCUMENTATION field in the entry panel:

• If the AUTO-SAVE DOCUMENTATION field was set to Y (Yes), documentation changes are automatically saved and the Save Documentation window is not displayed.
• If the AUTO-SAVE DOCUMENTATION field was set to N (No), documentation changes are not automatically saved, and the Save Documentation window is displayed as shown below. This window enables you to save or cancel the documentation changes.

  Figure 42 Vault Definition Save Documentation Window

VAULT VAULT_01 LIB CTT.PROD.VAULTS                              TABLE: $$VAULT

  COMMAN +-----------------------------------------------------------+  ===> CRSR

  +----- |                                                           | --------+

   VAUL  |   SAVE DOCUMENTATION ==> Y      (Y/N)                     |      

   LOCA  |                                                           |      

   ====  |   LIBRARY CTT.PROD.DOCS                                   | =======

   DESC  |   MEMBER  CTTDOCS                                         |      

   DESC  |                                                           |      

   OWNE  +-----------------------------------------------------------+         

   ADDRESS                                                                    

   PHONE       609-555-2684                                                   

   SCHEDULE    DAILY PROCESSING                                               

   SCHEDULE                                                                  

   DOCMEM  CTTDOCS       DOCLIB CTT.PROD.DOC                                 

   ===========================================================================

   DOC THIS SCREEN SHOWS WHERE THE DOCUMENTATION WILL APPEAR ON THE SCREEN   

   DOC WHEN YOU USE THE DOC COMMAND. AS YOU CAN SEE, THE LINES FOLLOWING      

   DOC THE DOCUMENTATION WILL BE "PUSHED" DOWNWARD. ENTER THE DOC COMMAND

   DOC AGAIN TO MAKE THIS DOCUMENTATION DISAPPEAR.      

   DOC                                                            

  ============================== GLOBAL CAPACITY ==============================

   CAPACITY 00001000      TYPE   SLOT     MEDIA 3400

  FILL IN VAULT DEFINITION. CMDS: EDIT, SHPF, DOC                        09.00.26

You can change the name of the library or member in the window.

• Enter Y (Yes) in the SAVE DOCUMENTATION field to save the changes.
• Enter N (No) in the SAVE DOCUMENTATION field to cancel the changes.

After specifying Y or N, the Vault List screen is displayed.