Vault Definition Entry Panel

Figure 34 Vault Definition Entry Panel

----------------- CONTROL-M/Tape VAULT DEFINITION ENTRY PANEL -------------(TV)

COMMAND ===>

SPECIFY LIBRARY, TABLE NAME, VAULT NAME

  LIBRARY   ===> CTT.PROD.PARM

  TABLE     ===>                      (Blank for table selection list)

  VAULT     ===>                      (Blank for vault selection list)

  SHOW VAULT DOCUMENTATION ===> N     (Y/N)

  AUTO-SAVE DOCUMENTATION  ===> N     (Y/N)

USE THE COMMAND "SHPF" TO SEE PFK ASSIGNMENT                           11.51.11

Note: If you use the selection list fields, their values are not erased until you exit the entry panel by pressing END (PF03/PF15).

Fill in entry panel fields LIBRARY, TABLE, and VAULT as described below to open the desired display:

• Type Y or N in the SHOW VAULT DOMENTATION field to determine whether vault documentation lines are displayed when the vault is displayed. For more information, see Vault Documentation.
• Type Y or N in the AUTO-SAVE DOCUMENTATION field to determine whether changes made to documentation are automatically saved (meaning, without special prompting) when updating the rule. For more information, see Rule Documentation.
• To display the list of tables in a library, do the following:

1. Type the library name.
2. Either leave the table name blank, or type part of a table name together with mask characters (* and ?).
3. Press Enter.

• To display the list of vaults of a specific rule, do the following:

1. Type the library name.
2. Type the table name.
3. Press Enter.

   If the table does not exist, the screen for defining a new vault in the table is displayed.

• To display the details of a specific vault (Vault Definition screen), do the following:

1. Type the library name.
2. Type the table name.
3. Type the vault name.
4. Press Enter.

   If the table does not exist, or the vault for the specified table does not exist, the screen for defining a new vault in the table is displayed.

   Note: If you enter the screen for defining a new rule and want to leave the screen without defining a rule, use the CANCEL command.