R2: Control-M/Restart data set cleanup

The Control-M/Restart Dataset Cleanup utility is used to manually request data set cleanup.

The utility places a CONTROLR step in the job stream and submits the job. The CONTROLR step performs the data set adjustment (including step adjustment, if necessary) and then stops. No further job steps are executed (the utility adds a step that prevents the execution of the other steps in the job).

The Control-M/Restart Dataset Cleanup screen (Figure 3) can be displayed in the following ways:

• Select Option R2 in the IOA Online Utilities menu. The IOA Online Utilities menu is displayed by requesting Option 6 on the IOA Primary Option menu under ISPF, or by activating CLIST IOAUTIL from the TSO Command Processor.
• Activate CLIST CTRCCLN from the TSO Command Processor.

To exit the Control-M/Restart Dataset Cleanup panel without activating the utility, press END (PF03/PF15).

Figure 3 Control-M/Restart Dataset Cleanup Panel

--------------------- Control-M/RESTART DATASET CLEANUP ---------------------

COMMAND ===>

TRACE MODE: ===> . . . . . . . . .

OPERATION MODE: ===> J - JCL, S - SCHEDULE

JCL LIBRARY MODE:

JCL LIBRARY ===> CTM.TEST.JCL

MEMBER NAME ===>

SCHEDULE LIBRARY MODE:

SCHEDULING LIBRARY MODE ===> CTM.PROD.SCHEDULE

TABLE NAME ===> JOB NAME ===>

CLEANUP PARAMETERS:

ORDER ID ===>

FROM PGMSTEP ===> TO PGMSTEP ===>

FROM PROCSTEP ===> TO PROCSTEP ===>

AUTOEDIT PARAMETERS:

OWNER ===> N29A

GLOBAL AUTOEDIT LIBRARY ===> CTM.PROD.PARM

WDATE ===> 09 11 00 (DD MM YY)

ODATE ===> 09 11 00 (DD MM YY)

ENTER YES TO CONTINUE ===>

The CTRCCLN utility operates in either JCL Library mode or Scheduling Library mode, according to the parameters you specify in the utility panel: