Any combination of the following actions may be performed when the specified event occurs. They are specified in DO statements in the rule definition:
DO COND statement – Prerequisite conditions may be added to or deleted from the IOA Conditions file. This may trigger the submission of jobs in the Active Jobs File.
DO FORCEJOB statement – A Control-M table or individual job can be forced (that is, ordered to the Active Jobs File regardless of its basic scheduling criteria). Jobs can be forced for one of the following reasons:
To start a new process in Control-M (that is, new job submission).
To enable Control-M to assume full control of an externally submitted job that triggers the event. These jobs are referred to as on spool jobs, discussed in On Spool jobs.
DO STOPJOB statement – Stop (terminate) the job in which the event occurs at the end of the current job step.
The following actions can be defined if Control-O is installed:
DO RULE statement – Control-O rules can be invoked within the current rule.
DO SHOUT statement – Messages can be sent via the Control-O Shout facility.
