|
|
|
|
|
Control-M/Analyzer reads the specified sysout according to the specified DD name, procedure step, and program step. The sysout must have been written by a previous step.
When ON SYSOUT is specified, the output must be in HELD state and FREE=CLOSE must be specified in the DD statement that references the output.
ON SYSOUT can be specified under both JES2 and JES3.
Control-M/Analyzer AutoEdit and Local variables can be embedded in the PROCSTEP, PGMSTEP, DDNAME, and JOBNM parameters. The variables are resolved (replaced) at time of rule execution. For additional information on AutoEdit processing see Control-M/Analyzer Variables.
If the JOBNM parameter is not specified, the sysout of the current job is processed. Otherwise, the job name of every sysout in the system is examined to find the most recently produced sysout with the specified job name. If the specified job name is not found, no sysout is processed.
Parent Topic |