Activating Utility CTOFANCI

For more information about how to invoke utility CTOFANCI, see Conversion Steps.

The following control statements show all parameters that can be specified for utility CTOFANCI. This section describes each parameter is described in detail.

Figure 1 Control Statements for Utility CTOFANCi

TYPERUN   OUTDSN=outdsn,OUTMEMNAME=memname,MODE={NORMAL|SIMULATION},

          [OUTVOL=volser,][OUTUNIT=unitname,]

          [OUTTRKS1=tracks,][OUTTRKS2=tracks,]

          [OUTDIR=dirblocks,][RLSE=Y|N,]

          [SYSOUT=sysout-class,][RPTSRCDSN=dsn|DUMMY,]

          [RPTRULESDSN=dsn,][RPTRULESMOD=Y|N,]

          [RPTSRCMOD=Y|N,][RESET=OUTLIB|NONE,]

          [OUTBLKSZ=block-size,][OUTCOMMENTS=Y|N,]

          [RESTARTDS=dsname|dsnid,] [SWEEK=SUN|MON,]

          [DAYTIME=+HHMM|-HHMM,]

          [RESTARTMEM=memname,][RULEPROGRESS=nn,]

          [LINESEQ=NONE|STD|AUTO|col1-col2,][SIMLINELIM=nnn,]

          [RULEWARNLIM=nn,][STOPAFTER=nnn,]

          [DUPPREF=prefix,][RULEMODE=T|P,][RULEOWNER=ownerid]

INCLUDE DSN=dsname,MEMBER=memname

INCLUDE ...

The following rules apply to the syntax for control statements specified for utility CTOFANCI:

• Multiple INCLUDE statements can be specified for the utility.
• Each control statement (that is, a TYPERUN or INCLUDE statement) can span multiple lines.
• Specification for each parameter in a control statement must be contained in a single line.
• If not all parameters of a statement fit on a given line, a comma must appear after the last parameter on the line and subsequent parameters must be specified on subsequent lines. Positions between the comma and the end of the line must contain only blank spaces.
• To enter a comment line, specify an asterisk (*) in column 1 of the line.