General Information

DO SMSMSG can be used only in ON SMS rules.

The message specified in the MESSAGE subparameter, can be used to provide informative text regarding data set allocation. Up to six sequential lines of SMS message text can be written. Specify the sequential number of the line of message text in the ID field. Information about the data set allocation can then be viewed and saved.

The messages appear on the TSO screen, or in the job log under the following message IDs:

• IGD1004I, for Data class selection
• IGD1005I, for Storage class selection
• IGD1006I, for Management class selection

Note:

The DO SMSMSG statement should not be placed at any point after the following statements:

• DO ASKOPER
• DO COMMAND with WAIT RESPONSE
• DO KSL
• DO SHELL
• DO TSO
• DO WAIT

The above statements would cause the execution of the rule to be suspended. However, the allocation of the new data set would continue, without waiting for the rule to complete, and the DO SMSMSG statement would not override the SMS class that ACS assigns to the data set.