Operator Command Screen

The Operator Command screen is displayed after specifying an MVS or VM command using the COMMAND option in the Automation Options facility. The screen displays the results of the specified MVS or VM command.

Figure 51 Operator Command Screen

---------< D >---------  CONTROL-O - Operator Command --------------------(OA)

COMMAND ===>                                                    SCROLL===> HALF

                          CONSOLE RESPONSE

   ---> D T

IEE136I LOCAL: TIME=08.48.25 DATE=2000.022  GMT: TIME=06.48.25 DATE=2000.022

====== >>>>>>>>>>>>>>>   NO MORE ENTRIES IN THE LIST     <<<<<<<<<<<<<<< ======

CMDS: SHPF, REFRESH(ENTER-KEY)                                        08.52.42

The following information is displayed on the screen:

• The command, as entered, is displayed on the first one or two lines.
• The console response, as it would appear had the operator specified the command from the console, is displayed on subsequent lines.

Note:After the command has been entered, Control-O waits a preset length of time before displaying the console response. If the console response is relatively slow, or the output relatively large, a partial response may be displayed at first. In this case, refresh the screen using the REFRESH command (PF04/PF16 or Enter) periodically until the complete console response has been displayed.