Passing data to monitors

In most the cases, JCLs and schedule definitions are passed to Control-M JCL Verify monitors using the names of the corresponding libraries and members. When the Control-M JCL Verify verification is requested from the editing or changing dialog, then the contents of the JCL or schedule definition is transferred instead, because the data was probably changed by the user and might not be saved yet.

Passing data by the names of the JCL and schedule definition libraries and members requires that these datasets must be accessible in the system where the Control-M JCL Verify verification is to be performed (the system where the target Control-M JCL Verify monitor is running). This is also relevant for the datasets referenced by the members and definitions required by Control-M JCL Verify verification, for example JCL libraries defined in the corresponding schedule definitions.