The INTERVAL SEQUENCE parameter defines an interval sequence between reruns or cyclic runs of the same job.
Once the job has run, the Control-M Monitor does not rerun or resubmit the job unless both the following conditions are satisfied:
The FROM subparameter specifies the point from which the interval is measured. The values set for this subparameter have the following effects:
A Rerun command (R) can be performed only after all planned intervals have been completed.
The figure below shows an example of the INTERVAL SEQUENCE parameter.
Figure 238 INTERVAL SEQUENCE Parameter Example
JOB: ADBBKPS LIB CTM.PROD.SCHEDULE TABLE: ADABAS
COMMAND ===> SCROLL===> CRSR
+---------------------------------------------------------------------------+
===========================================================================
OUT
AUTO-ARCHIVE Y SYSDB Y MAXDAYS MAXRUNS
RETENTION: # OF DAYS TO KEEP 030 # OF GENERATIONS TO KEEP
SYSOUT OP (C,D,F,N,R) FROM
MAXRERUN 9 RERUNMEM
CYCLIC TYPE: V INTERVAL FROM
INTERVAL SEQUENCE: + 00030 M + 00004 H + 00007 D + +
+ + + + +
SPECIFIC TIMES: TOLERANCE
+ + + + +
Parent Topic |