|
|
|
|
|
DO STOPCYCL is intended for use with all cyclic tasks (cyclic job, cyclic STC, emergency cyclic job and emergency cyclic STC). It interrupts a job cycle after the current run, so that once the job completes its current run, it does not run again. This parameter does not change the status (OK or NOTOK) assigned to job during the last cycle.
After DO STOPCYCL has interrupted a job, commands RERUN or RESTART can be used in the Active Environment screen to continue the job cycle from where it stopped. Commands RERUN and RESTART resume the stopped cyclic tasks without waiting for a cycling interval to occur. After the job restarts, it continues its normal cyclic interval as before.
Parent Topic |