The following conditions must be satisfied before the Tape Pull List procedure can forecast tapes for a specific job:
The submission message must be present in the simulation output Log file.
The corresponding job has a WAIT SCHEDULE status in the simulation input Active Jobs file.
Reports are not produced if one or more of the following situations exist:
None of the "submitted" jobs required tapes.
Jobs requiring tapes were not "submitted" by the simulation because their submission criteria were not satisfied.
An invalid Active Jobs file was specified as an input for the Tape Pull List procedure.
An invalid Log file was specified as an input for the Tape Pull List procedure.
JCLFILE ONLY was specified as an input parameter for the procedure.
No reports were requested from the procedure through the input parameters, that is, the default was "no reports".
The procedure does not recognize tape data sets. For more information, see the description of the Tape Pull list utility in the discussion of Control-M customization in the INCONTROL for z/OS Installation Guide.
