CTDDIG Parameters

The following parameters can be specified in the EXEC statement that invokes the CTDDIG JCL procedure:

Table 223 CTDDIG Parameters

Parameter	Description
DBFILE	File to be checked. Mandatory. Valid values are: ACT – Active User Report List file PRM – Permanent User Report List file HST – History User Report List file MIG – Migration User Report List file (Control-V only) MG1-MG9 – MUF partition of Migrated User file (Control-V only)
MODE	Mode in that the utility is run. Optional. Valid values are: TEST – Messages are issued about detected problems, but errors are not fixed. Default. TESTMRK – Messages are issued about detected problems, but errors are not fixed. If no errors are detected for a specific alternative index component, it is marked as ready for read. CHANGE – Messages are issued and errors are fixed. If no errors are detected for a specific alternative index component, it is marked as ready for read.

Parameter

Description

DBFILE

File to be checked. Mandatory. Valid values are:

MODE

Mode in that the utility is run. Optional. Valid values are:

TEST – Messages are issued about detected problems, but errors are not fixed. Default.
TESTMRK – Messages are issued about detected problems, but errors are not fixed. If no errors are detected for a specific alternative index component, it is marked as ready for read.
CHANGE – Messages are issued and errors are fixed. If no errors are detected for a specific alternative index component, it is marked as ready for read.