Parameter P=position is used to indicate that names in parameters N and O are partial names.
(When parameter P is not specified, the condition or resource names in both parameter N and parameter O are treated as full non-generic names, padded with trailing blanks if necessary.)
Either of two values can be specified for parameter P: P=nn or P=*.
For example,
Assume parameters O=BKP and P=5 are specified.
This value indicates that the character string in the condition or resource name field that matches the name or string specified in parameter O is replaced by the name or string specified in parameter N, regardless of character position. In this case, multiple replacements can occur.
If, in attempting to replace a string with a longer string, and the condition or resource name becomes longer than 20 characters, the change is not performed.
Note: When parameter P=* is specified, the value of subparameter qualifier in both parameter N and parameter O is treated as if ?s were specified.
WARNING: The use of P=* with IN or OUT parameters is not supported when long condition names in job scheduling definitions are subject to modification.
Parent Topic |