Installing and implementing automatic restart management for IOAGATE

Follow the instructions to set up an automatic restart management policy as specified in the section of IBM publication z/OS V1Rx MVS Setting Up a Sysplex that discusses automatic restart management parameters for administrative data utility. Some of the restart parameters are discussed in Restart parameters.
Note: Your system does not need to specify an automatic restart management policy if the default values are acceptable. The default values, if any, are described under each parameter in IBM publication z/OS V1Rx MVS Setting Up a Sysplex, in the section discussing automatic restart management parameters for administrative data utility.
Specify the IOAGATE ARMELEM parameter in the ECAPARM member as described in Step 20 – Install IOAGATE (optional).
Stop and then restart the IOAGATE monitor. At restart, IOAGATE checks the ARMELEM parameter in ECAPARM and, if specified, registers as an element of automatic restart management. The IOAGATE monitor then issues the following message:
ECAG0HI ENABLED FOR THE AUTOMATIC RESTART MANAGEMENT FUNCTION

If IOAGATE fails to activate ARM when starting up, it issues the following message:

ECAG0JW AUTOMATIC RESTART MANAGEMENT REQUEST FAILED R15=XX REASON=XXXX