Messages XMM600 through XMM6xx

This group includes messages for the IOA (infrastructure) product.

XMM645I MONITOR USER PGM APPLID TERMINAL START LASTUSED ST

Explanation: After an operator DISPLAY command to one of the Online monitors, this header message for message XMM646I is issued.

Corrective Action: No action is required.

XMM646I monName user pgm applId terminal start lastUsed st

Explanation: After an operator DISPLAY command to one of the Online monitors, this message is displayed for each active user.

The variables in this message are:

• monName - the name of the monitor started task
• user - the user name (ID)
• pgm - the program name
• applId - the application ID
• terminal - VTAM terminal ID
• start - user sign-on time
• lastUsed - time stamp of last user entry
• st - Valid values are:
  • W (Waiting for user data)
  • A (Active user is waiting for response)

Corrective Action: No action is required.

XMM647E monName - LOAD OF pgm FAILED. SIGNON OF USER usr FAILED

Explanation: Load for a module requested during user sign-on to the Online facility failed. The user main program as specified by Online monitor sign-on exit or by default (CTMXMAN, CTMXMAND, CTDXMAN, or CTDXMANU) cannot be found in the Online monitor STEPLIB libraries.

Sign-on to the specified IOA Online monitor is terminated.

Corrective Action: Contact your INCONTROL administrator to find out why the program is missing. If the problem is not resolved, call BMC Customer Support.

XMM648S monName - ONLINE MONITOR ENDED WITH ERROR

Explanation: Highlighted, unrollable message.

A severe error has occurred. IOA Online monitor shutting down.

Detailed information on this error is available in the messages which were previously displayed on the operator console.

The specified IOA Online monitor is shutting down.

Corrective Action: Check the system log for additional messages.

XMM649E monName - INVALID MODIFY PARAMETERS. VALID PARAMETERS ARE:

Explanation: An invalid parameter was passed to the specified IOA Online monitor by an operator modify command (F). A list of valid modify parameters will appear on the operator console following this message.

The modify command is rejected.

Corrective Action: Enter a correct modify parameter.