This group includes messages for the Control-D, Control-D/Image, and Control-D/Page on Demand products.
Explanation: An error occurred when using the extended MCS console.
Control-D terminates the extended MCS console and starts using a standard method for preventing the mixing of chunks during deferred printing.
Corrective Action: Keep a system log of the problem, and a job log of the Control-D printer monitor. It is recommended to stop, then restart, the Control-D monitor to prevent a possible mixing chunks problem.
Explanation: This information message is generated when Control-D activates an extended MCS console to prevent the mixing of chunks during deferred printing.
When APPLY is set to YES for optional wish WD2624, Control-D uses an extended MCS console to prevent the mixing of chunks during deferred printing.
Corrective Action: No action is required.
Explanation: There is no response from the extended MCS console used by Control-D to prevent the mixing of chunks during deferred printing.
Control-D stops using the extended MCS console and starts using a standard method for preventing the mixing of chunks during deferred printing.
Corrective Action: Keep a system log of the problem, and a job log of the Control-D printer monitor. It is recommended to stop, then restart, Control-D monitor to prevent a possible mixing chunks problem.
Explanation: The parameter specified for the IOATEST utility is invalid.
The IOATEST utility terminates with a condition code of 08.
Corrective Action: Correct the syntax of the parameters to IOATEST.
Explanation: The value of a parameter that should be numeric is nonnumeric.
The IOATEST utility terminates with a condition code of 08.
Corrective Action: Make sure the value of the parameter is numeric.
Explanation: Numeric parameter is not within the defined range.
The utility terminates with a condition code of 08.
Corrective Action: Make sure the value of the parameter is within the defined range.
Explanation: More than ten minor lines were specified for a multi-line message; 10 is the maximum allowed.
The IOATEST utility terminates with a condition code of 08.
Corrective Action: Make sure that no more than 10 minor lines are specified.
Explanation: The value specified for the parm parameter exceeded 4 characters.
The parameter value is truncated to the first four (leftmost) characters. Processing continues.
Corrective Action: Specify a valid value for the parm parameter.
Parent Topic |