Messages JESD00 through JESDxx

This group includes messages for the Control-M for z/OS, Control-M/Assist, Control-M/Links for z/OS, and Control-M/Restart products.

JESD50S READING JOB DATA BY IEFSSREQ FAILED num TIMES. LAST RC rc. fileNum_jobName/jobId

Explanation: This message is issued after the number of unsuccessful attempts to read job data by subsystem request reaches the defined maximum. After searching for the job data the maximum number of times, Control-M changes the job status to DISAPPEARED and stops searching.

The job status changes to DISAPPEARED.

Corrective Action: For the appropriate action, refer to the section on the Control-M monitor and JES in the INCONTROL for z/OS Administrator Guide.

JESD51S OID=orderId NO MORE SPACE FOR SYSOUT ARCHIVING (SB37)

Explanation: No space is available on the designated volumes to archive SYSDATA sysouts.

Archiving of SYSDATA is not completed due to lack of the space on the volumes designated for allocation of the Archived Sysout Datasets.

Control-M issues additional messages describing the nature of the problem and terminates.

Corrective Action: Please do the following before attempting to restart the Control-M monitor:

1. Make sure that there is sufficient free space on the volumes defined by the AMVOL parameter of the CTRPARM member.
2. If it is not possible to provide enough space on the volumes defined by the AMVOL parameter of CTRPARM, please add another volume to the list of volumes designated for allocation of the Archived Sysout Data Sets.
3. If it is not possible to add more volumes to the AMVOL parameter of the CTRPARM member, remove all of them. Then the Archived Sysout Data Sets will be allocated only according to the AMUNIT parameter of the CTRPARM member.
4. Start the Control-M monitor.
5. If the problem persists, prepare the Control-M monitor full output and contact BMC Customer Support.

JESD52W OID=orderId PROBLEM PROBABLY CAUSED BY PREVIOUS MVS SYSTEM CRASH. END-OF-FILE ASSUMED

Explanation: A failure occurred during sysout processing.

Control-M received a bad return code from JES (feedback code of 0C0204) during sysout processing. This is a typical return code for a system crash event which prevented JES from closing the sysout in a standard manner.

The Control-M monitor ignores the return code, assumes that end-of-file has been encountered, and continues normally.

Corrective Action: No action is required.

JESD53S OID=orderId UNABLE TO ALLOCATE COMPRESSED DATASET FOR SYSDATA SYSOUT ARCHIVING. LAST RC=rc

Explanation: Dynamic allocation of an Archived Sysout Dataset has failed.

This message will be preceded by other messages detailing the nature of the problem, the DD name, the return code, and the reason code.

The Archived Sysout Dataset is not allocated and Control-M terminates.

Corrective Action: Record all relevant messages, prepare the Control-M monitor full output, and contact BMC Customer Support.