Messages COMG00 through COMGxx

This group includes messages for the Control-M for z/OS, Control-M/Assist, Control-M/Links for z/OS, and Control-M/Restart products.

COMG84I OPERATION WILL BE RE-ATTEMPTED

Explanation: The system will try again to perform an operation that failed.

This message follows other messages that provide details about an error that occurred.

Normal processing continues, and the system tries repeatedly to perform the operation until it succeeds, or until the retry limit is reached. When the retry limit is reached, the system tries to recycle the SNA channel only.

Corrective Action: No action is required.

COMG85I OPERATION WILL BE RE-ATTEMPTED AFTER ONE MINUTE

Explanation: A failed operation will be retried until the retry limit is reached. This message follows other messages that provide details about an error that occurred.

The failed operation is retried. When the retry limit is exceeded, an attempt is made to recycle communication.

Corrective Action: No action is required.

COMG89W APPCCMD appccmd FAILED. APPLID=applId R15=r15 R0=r0 RPL6RC=rc PARTNER LU=partner_lu

Explanation: An APPC command has failed. The reason for the failure may be temporary, such as a shortage of storage.

This message is followed by the COMG84I message, indicating the action that will be taken by the Control-M NJE Gateway.

This message may be preceded by another message that provides more information about the error that occurred.

The following information in this message is for the VTAM system programmer:

• appccmd - the command that failed
• applId - the identity of the application that issued the command that failed
• r15 - the value in Register 15 returned by VTAM
• r0 - the value in Register 0 returned by VTAM
• rc - the RPL6RC return code returned by VTAM

The following fields are documented in the VTAM Programming for LU 6.2 Manual:

• APPCCMD - in the section on LU 6.2 macro instruction syntax and operands
• RPL6RC - in the appendix on return codes
• R0 and R15 - in the section on handling errors

Corrective Action: If a second message gives a probable cause for the error, proceed according to the User Response recommended in that message. Otherwise, contact your VTAM system programmer.

COMG90E APPCCMD appccmd FAILED. APPLID=applId R15=r15 R0=r0 RPL6RC=rc PARTNER LU=partner_lu

Explanation: An APPC command failed.

This message is followed by a message indicating the action that will be taken by the Control-M NJE Gateway.

This message may be preceded by another message that provides more information about the error that occurred.

The following information in this message is for the VTAM system programmer:

• appccmd - the command that failed
• applId - the identity of the application that issued the command that failed
• r15 - the value in Register 15 returned by VTAM
• r0 - the value in Register 0 returned by VTAM
• rc - the RPL6RC return code returned by VTAM

The following fields are documented in the VTAM Programming for LU 6.2 Manual:

• APPCCMD - in the section on LU 6.2 macro instruction syntax and operands
• RPL6RC - in the appendix on return codes
• R0 and R15 - in the section on handling errors

Corrective Action: If a second message gives a probable cause for the error, proceed according to the User Response recommended in that message. Otherwise, contact your VTAM system programmer.