Messages BMS900 through BMS9xx

This group includes messages for the Control-D, Control-D/Image, and Control-D/Page on Demand products.

BMS971S OPEN OF CONTROL-D ACTIVE MISSIONS FILE FAILED

Explanation: The CTDFRAMS Control-D utility, which is used to allocate and format the Active Missions file, failed to open the file for formatting.

Possible causes are:

• The DAAMF DD statement is missing.
• There is insufficient memory for the job.

The utility stops executing with a condition code of 08.

Corrective Action: Correct the JCL and rerun the job.

BMS972I BUILDING OF CONTROL-D ACTIVE MISSIONS FILE STARTED

Explanation: This information message indicates that the CTDFRAMS utility, which allocates and formats the Active Missions file, has started.

Corrective Action: No action is required.

BMS973I BUILDING OF CONTROL-D ACTIVE MISSIONS FILE ENDED

Explanation: This information message indicates that the CTDFRAMS utility, which allocates and formats the Active Missions file, has ended normally.

Corrective Action: No action is required.

BMS974S CONTROL-D ACTIVE MISSIONS FILE WAS NOT BUILT

Explanation: The CTDFRAMS utility failed.

Corrective Action: Look for additional clarification messages on the IOA Log.

BMS975S CONTROL-D ACTIVE MISSIONS FILE WRITE ERROR

Explanation: I/O error while formatting the Control-D Active Missions file.

This error may occur when there is incompatibility between the definition of the Active Missions file in one or more of the following:

• the installation parameters (CTDPARM)
• the JCL SPACE parameter
• the DCB parameters

The utility stops executing with a condition code of 08.

Corrective Action: Correct either the JCL or the installation parameters.

BMS976S OPEN OF IOA LOG FILE FAILED

Explanation: The CTDFRAMS utility, which is used to allocate and format the Active Missions file, could not open the IOA Log.

Possible causes are:

• The DALOG DD statement is missing.
• The file allocated to the DALOG DD statement is not the IOA Log file.
• The file allocated to the DALOG DD statement is the IOA Log file, but it is from a different version or a different IOA installation.
• The IOAFRLOG utility, which allocates and formats the IOA Log, has not yet been run, or did not finish executing normally.

The utility stops executing with a condition code of 08.

Corrective Action: Correct the JCL and rerun the job.