Messages BAT900 through BAT9xx

This group includes messages for the Control-D, Control-D/Image, and Control-D/Page on Demand products.

BAT9A3I BUILDING OF CONTROL-D ACTIVE TRANSFER FILE STARTED

Explanation: This information message indicates that the CTDBAT program, which formats the Active Transfer file, started.

Corrective Action: No action is required.

BAT9A4I BUILDING OF CONTROL-D ACTIVE TRANSFER FILE ENDED

Explanation: This information message indicates that the CTDBAT program, which is used for formatting the Active Transfer file, has ended normally.

Corrective Action: No action is required.

BAT9A5S CONTROL-D ACTIVE TRANSFER FILE WAS NOT BUIL

Explanation: An error occurred during the formatting of the Active Transfer file (the CTDBAT program).

Formatting is terminated.

Corrective Action: Check the system log for a previous message regarding the error. Correct the problem, and reformat the file.

BAT9A6S OPEN OF CONTROL-D ACTIVE TRANSFER FILE FAILED

Explanation: The probable cause is a missing DAATF DD statement.

Formatting is terminated.

Corrective Action: Check and correct the DAATF DD statement.

BAT9A7S CONTROL-D ACTIVE TRANSFER FILE WRITE ERROR

Explanation: The format routine received an I/O error when accessing the Active Transfer file. An I/O error was encountered by the CTDBAT program when accessing the Active Transfer file.

Possible causes are:

• A hardware failure may have occurred.
• The Active Transfer file specification contains invalid parameters.

Formatting is terminated.

Corrective Action: Do one of the following:

• After the hardware problem has been resolved, reformat the file.
• Check and correct the DCB parameters specified in the DAATF DD statement, then reformat the file.

BAT9A8S OPEN OF IOA LOG FILE FAILED

Explanation: The IOA Log file is unavailable for processing.

Formatting is terminated.

Corrective Action: Check and correct the DALOG DD statement, then reformat the Active Transfer file.

BAT9A9S NUMBER OF RECORDS IN ACTIVE TRANSFER FILE IS LESS THAN 3

Explanation: The CTDBAT program determines the number of records for the Active Transfer file from the ATFBLK installation parameter in the CTDPARM member. This value cannot be less than 3.

Formatting is terminated.

Corrective Action: Correct the CTDPARM member, then reformat the Active Transfer file.