The IOA Archive Server is supplied with internal debugging facilities. Normally, these facilities are dormant. However, if required (for example, your BMC technical representative requests debugging information), you can activate the debugging facility as follows:
S IOASMON,DEBUG=level
F IOASMON,SET DEBUG=level
The debugging level can be any value from 0 (no debugging) to 255. The required debugging level, and instructions to set it with a START or MODIFY command, are supplied by your BMC technical representative.
When the IOA Archive server debugging facility is successfully activated, the following message is displayed on the operator console:
IOA128I IOASMON – DEBUG LEVEL IS SET TO level
Note: You should not activate the IOA Archive server with parameter DEBUG on a regular basis for the following reasons:
F IOASMON,SET DEBUG=0
When the IOA Archive Server debugging facility is successfully deactivated, the following message is displayed on the operator console:
IOA128I IOASOM – DEBUG LEVEL IS SET TO 0
Parent Topic |