|
|
|
|
|
By default, the MQ Series decollation process begins when Control-D is started. Users can toggle MQ Series decollation off and on through operator commands.
Decollation processing from the MQ Queue might be deactivated if an error occurs while updating the Active User file during decollation. In this case the processing is deactivated to prevent moving messages to the Escape MQ Queue without the creation of relevant reports in the Active user file.
The process might also be deactivated, if decollation 'ENDED NOT OK' and relevant (special) error messages occur.
To stop processing decollation from MQ Series issue the following operator command:
F CONTROLD,STOPMQ |
To start processing decollation from MQ Series issue the following operator command:
F CONTROLD,STARTMQ |
Parent Topic |