To obtain information about Control‑O usage of internal storage areas, issue operator command
F CONTROLO,STORAGETABLE |
Note: Only issue this command if requested by your BMC Customer Support representative.
Information message CTO356I is issued in response to this command. The figure shows an example of this message.
Figure 69 Information Message CTO356I Example
CTO356I STORAGETABLE
NAME ADDRESS LEN(HEX) LEN(DEC)
DEST 00D495C8 00000108 00000264
FMIX 00000000 00000000 00000000
INX 0370A390 000000E8 00000232
MIX 036C0D28 00000504 00001284
MSGB 00045190 00018E70 00102000
PND 0358BAC8 00021534 00136500
SRVR 03673EB8 00001144 00004420
WSC 03614000 0001E000 00122880
NETMAP 00C014A0 00003B60 00015200
CTOWTO 831B3600 0002AA10 00174608 12/21/00 16.56 BO0709
CTOAIDT 00BA6D58 000082B8 00033464 12/06/00 12.18 WO0818
CTOALT 80B8FEC0 00003140 00012608 11/16/00 12.37
CTOMTO 00006FB0 0003E050 00254032 01/09/01 13.15
For more information about these messages, see the INCONTROL for z/OS Messages Manual.
Control‑O users can tune the PND and WSC by adjusting the values of the WAITPR# and WSCs# parameters in the CTOPARM member. However, the RQC cannot be tuned. Look for any PTFs that correct problems handling RQC.
Parent Topic |